|
5 Separately Controlled
5kV Outputs for Mass Spectrometers
Applications:
- Beam steering in electron guns
- Mass spectrometers
- Surface science instruments
|
 |
The HP5x5 provides 5 separately controlled 0 to 5kV outputs, at up to 300µA. Each one can be configured by the factory as positive or negative (combinations of polarity are possible e.g. 3 positive and 2 negative).
Each channel is controlled by its own 0 to +10V control signal, and each has its own 0 to +10V monitor output. The module is powered from 24V DC, and draws 2 Amps fully loaded.
| Electrical Specification |
|
INPUT VOLTAGE:
|
+24 volt at 2 amp. Negative input terminal common to HV earth return |
|
OUTPUT VOLTAGE 1:
|
20V to 5kV at 300µA. |
| OUTPUT VOLTAGE 2 to 5: |
As output 1. All outputs are individually controlled. |
| POLARITY: |
Each channel can be factory set either positive or negative (combinations such as 3 positive & 2 negative are possible). |
| Please note the following applies to each of the 5 outputs: |
|
CONTROLS (5 separate):
|
0 to +10V gives 0 to 5kV. |
| VOLTAGE MONITORS: |
0 to +10V represents 0 to 5kV (all 5 outputs).
Source resistance 10 kohm. |
| RIPPLE: |
Less than 150mV peak to peak on each output. |
|
LINE REGULATION:
|
Less than 50ppm for 1V change in input. |
|
LOAD REGULATION:
|
Less than 50ppm. |
|
OUTPUT TOLERANCE:
|
Better than 2% of control voltage. |
|
TEMPERATURE COEFFICIENT:
|
Better than 200ppm per °C. |
|
OPERATING TEMPERATURE:
|
0°C to +45°C. |
Mechanical Specification
|
|
SIZE:
|
216 x 155 x 52mm
|
|
OUTPUT CABLES:
|
By flying leads. Each cable 0.5 meter of URM43
|
| INPUT CONNECTOR: |
Molex 6 way & 12 way connector. |
| ORDERING INFORMATION: |
State unit type HP5x5 and polarity mixture
e.g. HP5x5-3PN2N (3 positive and 2 negative). |
|
PDF Downloads
|
|
|
Data Sheet | Installation Notes | Outline Drawing |
|
